 |
|---|
|
|---|
4 and 6 mm Articulating Flexible Borescopes | |
|---|---|
| These scopes are THE BEST value on the market!
These Top-of-the-line articulating scopes are built with precise hand craftsmanship made to last and withstand the rigors of internal inspections. Each unit contains a crystal clear, hi-resolution coherent image bundle of micron diameter fibers that can be directed in both +/- 120 degrees off axis to insure complete inspection viewing during the inspection. |
  |
Removable 90 Deg (Side View) Prism Tip Option | |
|---|---|
| The 4 and 6mm scopes can be ordered with optional miniature prism tips. Shown here is the 4mm prism tip. Simply thread on this tip and hand tighten- and now the scope can be used for side viewing and when the scope is articulated- you can look directly back- so this allows a very wide range of viewing angles beyond that of the just articulating the tip off axis. Note that jeweler's like workmanship required to manufacture such a small precision optical component. Not only does this require good cosmetics.... but all optical surfaces must be perfectly fit and aligned in this assembly. This is quite an engineering feat!..... Click on the images below to see an enlarged view. |     |
Full Articulation Control and easy operation | |
|---|---|
| Top Photo:While the scope is inserted into the inspection area- all that is required is finger touch control on the articulation arm to move the tip to view off axis. Bottom Photo: Up/Down Articulation control handle is shown close up- note the articulation lock releases very easily to help insure the scope naturally retracts back to the center position BEFORE being pulled out from the insertion hole. Our design is unlike other scopes that lock the tip firmly. When using "Fully locked" articulating scopes- damage can occur quite easily if the scope is pulled out inadvertently without loosening the lock- it will become hung up inside- hooked around at an angle. If further force is used to pull the scope out- it can cause major damage to scope. As good practice- all fiberscopes should be articulated back to the forward position before being removed from any insertion hole. This lower photo also shows a nice close up view of the focusing ring adjustment at eyepiece. |    |
Quality Materials and Workmanship | |
|---|---|
| Each scope is hand assembled from quality engineered materials to protect the fragile internal coherent image bundle |  |
| The light guide bundle is also protected by a flexible crush resistant material |  |
| Close up showing exit post from eyepiece designed to protect permanently attached light bundle. |  |
| Close up of the light guide connector for insertion into the light source. |  |
| Complete strain relief assembly is show designed to protect the fiberoptic bundles from severe bends as it exits the eyepiece |  |
| Here are some close ups of the most important part of the scope- the distal viewing tip. Hidden underneath the braided assembly are the precision miniature components that bring the image back to your eye. When each unit is assembled- all components are carefully aligned and epoxied beneath the stainless braid. These very small precision components inside the viewing tip- consist of a coherent image bundle with micron diameter fibers, non-coherent light carrier fiberoptic bundles and the miniature "Spine" articulation assembly to control the scope articulation |    |
| Close up of precision machined focus ring on eyepiece |  |
| Another close up of the DIN standard eyepiece installed on our scopes |  |
| Complete view of our 2 way articulating flexible borescope |  |
To order either our 4mm or 6mm scopes... CALL 800-530-3371 for a great price!Click here to see specifications and to compare with our other scopes All scopes are shipped with a hardshell die-cut foam padded carrying case- light source, video and other accessories are available |
|---|
UXR (800) 530-3371 * (805) 527-9219 * FAX (805) 520-8277
